Product brand: XUANFENG
Product name: CPU cooler fan
Product size: 120 (length) * 99 (width) * 155 (height) mm
Fan size: 120 x 120 x 25mm
3Pin speed: 1200 RPM ± 10%
4Pin speed: 600-1200 RPM ± 10%
Maximum air volume: 68CFM
Maximum noise: 30dBA
3Pin current: No lamp 0.33A with lamp 0.4A ± 10%
4Pin current: No lamp 0.12A with lamp 0.23A ± 10%
3Pin power: No light, 4W with light, 4.8W ± 10%
4Pin power: No light 1.4W with light 2.8W ± 10%
(The above data is for one fan. If there are multiple fans (air volume, noise, current, power), the data will increase.)
Fan bearings: hydraulic bearings
Working voltage: DC 12V
Process materials: copper and aluminum
Working life: 50000 hours
Fan interface: 3Pin (3-wire constant speed)/4Pin (4-wire temperature control)
Fan bearings: hydraulic bearings
Packaging method: boxed
Note:
Due to manual measurement, different measurement methods and tools, there may be slight dimensional deviations.
Due to differences in lighting, angle, and display, images may not reflect the actual color of the item
The following is an installation tutorial video for this product, hoping to be helpful to you. The products installed in the video are for reference only, but the installation method is the same.
Socket:
For Intel: LGA20112066 x79 x99 E5 E3 x299 2099
The following is a tutorial on installing a CPU cooling fan for the LAG: 2011/2066/2099/X79/X99/E5/E3/X299 slot. The product in the picture may be different from the one you purchased, but the installation method is the same.
1. As shown in the figure, it is suitable to install motherboards with built-in threads, such as LGA: 2011, X79, X99, 2099, X299, E3, E5. 2066, etc.
2. As shown in the figure, open the thermal conductive silicone grease and apply it evenly on the surface of the CPU.
3. As shown in the figure, peel off the protective film at the bottom of the radiator
4. As shown in the figure, the screw can be freely moved and adjusted.
5. As shown in the figure, place the screwdriver tool directly for tightening installation.
6. As shown in the figure, the installation method for dual fans is to add a fan on the back.
7. As shown in the figure, the interface CPUFAN, there is no need to worry about different interfaces. 3Pin/4Pin universal.
8. As shown in the figure, the blue arrow represents the air inlet, and the red arrow represents the air outlet.
9. As shown in the figure, the installation is completed.
Regarding the selection of interface types
3Pin or 4Pin interfaces are universal and can be installed without worrying about interface types
Fixed speed type: 3-pin fan, fixed speed, large air volume, good heat dissipation, but there may be relatively slight wind noise
Temperature control board: The 4Pin fan will intelligently adjust the fan speed based on the current CPU temperature, which is energy-saving and silent. Extend service life! (The motherboard needs to support and enable PWM speed regulation function, which is basically available on all motherboards)
