CONFAST® #6-8 Plastic Conical Blue Bantam Drywall Wall Anchor Kit PAK68, Includes (100) Anchors, (100) Screws and (1) Drill bit (201 Pieces)

The bantam plastic anchor is intended for light duty, non-critical applications. It can be used with a variety of foundation materials, including concrete, block, and brick. Although it is possible to use in wallboard, the holding values may vary and be unpredictable depending on the application. These anchors should not be used in overhead applications or in situations where holding values are crucial.
Kit includes：
(100) #6-8 anchors
(100) #6 x 1" Screws
(1) 1/4" carbide drill bit

Installation Instructions:
Using the provided drill bit, make a hole in the base to a depth of at least 1/4" deeper than the required embedment.
Clean the hole of dust and other material, blowing away as much as possible.
Tap the anchor into the hole so it is flush with the base material surface.
Position the fixture and insert the screw through the fixture to the top of the anchor and tighten.
Check that the screw thread fully catches the anchor body and that the anchor does not spin.