Tired of running into your front OEM turn signal stalks? Trying to get a clean blinker or marker light look? We got you covered! Our flush mount LED Turn Signals are made to fit in the OEM front turn signal opening of your Fairing. No cutting, drilling or modification to the plastics is required, but you may need to splice the wires. These LED Flush Mount Lights allow you to revert back to stock at any time. These blinkers have E-Mark (E-11) Certified raised stamped lenses. These Signals can also be used as Universal Surface Mount Signals, so you can install them on the front or rear with little to no modification, depending on your application. Application is only limited by your imagination.
Stats:
Dimensions: Multiple, please see photo(s)
Housing: Smoked High Impact Plastic
LED: 14 Amber Diodes
Base: White High Impact Plastic (Threaded Bolt and Nut Washer)
Wiring: Two Wire, 12 Volt Systems, Length approx 10 1/2 to 11 1/2 inches
Replaces Yamaha OEM (L/R):
2C0-83310-10-00 / 2C0-83320-10-00, 5PW-83310-10-00 / 5PW-83320-10-00,
39P-83310-10-00 / 39P-83320-10-00, 2MS-H3310-00-00 / 2MS-H3320-00-00
May also fit other bikes and/or OEM part numbers. Please do your own research if replacing with any OEM Part Number other than listed above.
Fitment Information: This can be used as a Universal Surface Mount LED Turn Signal Light; therefore, it has unlimited uses and mounting possibilities. This includes, but is not limited to: Sportbikes, Cruisers, Scooters, ATV, Quad, UTV, MX, Dirt Bike, Enduro, Dual Sport, Golf Carts, Trailers, and even Snowmobiles.
NOTE 1: This is an LED Turn Signal and can increase the Flash Rate of your turn signals. Flash Controllers (Resistors or LED Relays) are not required, but are recommended if you want to correct the hyper flashing.
Fitment:
Yamaha
09-10 TMAX - XP500
2005 YZS6T
03-13 R6 - YZFR6
06-09 R6S - YZFR6S
02-13 R1 - YZFR1
04-09 FZ6 - FZ600
09-15 FZ6R
11-13 FZ8
06-10 FZ1 - FZS1
2008 FZ10 - FZS10
15-18 YZF R3
