ANCEL DP500 Automotive OBD2 Scanner Odo-meter Key Programme Adjustment Tool DPF EPB ABS Injector Reset OBD2 Car Diagnostic Tool

ANCEL DP500 Support 11 Special Functions

✔ Oil Reset Service
The lightening of the car maintenance light indicates that the vehicle needs maintenance.Reset the mileage or driving time to zero after the maintenance,so the maintenance light will go out and the system will start a new maintenance cycle.

✔ ABS Bleeding
When the ABS contain air,the ABS bleeding function must be performed to bleed the brake system to restore ABS brake sensitivity.If the ABS computer,ABS pump,brake master cylinder,brake cylinder,brake line,or brake fluid is replaced,the ABS bleeding function must be performed.

✔ Gear Learning

✔ CVT Reset

✔ Battery Match
This function enables you to perform a resetting operation on the monitoring unit of vehicle battery,in which the original low battery fault information will be cleared and battery matching will be done.

✔ EPB Adaption

✔ TPS Adaption

✔ Steering Angle Reset
To reset the steering angle,first find the relative zero point position for the car to drive in straight line.Taking this position as reference,the ECU can calculate the accurate angle for left and right steering.After replacing the steering angle position sensor ,replacing steering mechanical parts(such as steering gearbox,steering column,end tie rod,steering knuckle),performing four-wheel alignment,or recovering car body,you must reset the steering angle.

✔ DPF Regeneration
DPF Regeneration is used to clear PM(Particulate Matter)from the DPF filter through continuous combustion oxidation mode(such us high temperature heating conbustion,fuel additive or catalyst reduce PM ignition conbustion)to stabilize the filter perfornance.

✔ Injector Coding
Writing injector actual code or rewrite code in the ECU to the injector code of the corresponding cylinder so as to more accurately control or correct cylinder injection quantity.After the ECU or injector is replaced,injector code of each cylinder must be confirmed or re-coded so that cylinder can better indentify injectors to accurately control fuel injection.

✔ Suspension Matching
This function can adjust the height of the body.When replacing the body height sensor in the air suspension system,or coontrol module or when the vehicle level is incorrect,you need to perform this function to adjust the body height sensor for level calibration.

ANCEL DP500 Key Programming Tool Supported Model

BMW, PORSCHE, BENZ, HONDA/ACURA, CITROEN/PEUGEOT, BYD, GREATWALL, VW/SEAT/SKODA/AUDI, FIAT, TOYOTA, FORD, JAGUAR, GEELY, CHRYSLER/DODGE/JEEP, RENAULT, DACIA, SUZUKIT , LANDROVER, MAZDA, LUXGEN, OPEL, CHERY, KIA, NISSAN/INFINITI, ROEWE, MITSUBISHI, SSANGYONG, SUBARU, SMART, GM, ISUZU, HYUNDAI, IVECO, ZOTYE, VOLVO, DAEWOO

Key Programming Highlights
-Ford EXPLORER/EXPLORER SPORT/TRANSIT CUSTOM/RANGER/FUSION etc supports up to 2019

-Renault CLIO/CAPTURE/DUSTER/KOLEOS etc supports up to 2015

-GM EQUINOX/MALIBU/TERRAIN supports to 2020

-GM CASCADA /ENCLAVE/REGAL/ESCALADE/CAMARO/IMPALA etc supports up to 2019

-Hyundai ACCENT/ELANTRA SEDAN/G90/GENESIS/KONA/SONATA etc supports up to 2019

-Landrover DISCOVERY 4/RANGE ROVER/RANGE ROVER EVOQUE supports up to 2015

-Volvo S60/V40/XC60 supports to 2017

-MAZDA MAZDA 6/MAZDA CX-3/MAZDA CX-5 etc supports up to 2018

Mileage Correction Highlights
-Chrysler 300C/PACIFICA/CHALLENGER/CHARGER/DURANGO/RAM etc supports up to 2018
-Ford F250/F350/F450/F550/FIGO/ASPIRE/KA supports up to 2018
-Renault CAPTUR/CLIO/TRAFIC IV supports up to 2017
-GM TRAILBLAZER supports up to 2019
-GM ESCALADE / XTS / COLORADO supports up to 2018
-Support part of ALFA/Porsche mileage correction