Chicken Feed Grinder Pellet Mill Machine Farm Animal Food Granulator 10mm Holes Plate 3 Head Rollers 200KG/H

Description:
Feed granulator is widely used in large, medium and small aquaculture, grain feed processing plants, livestock farms, poultry farms, individual farmers and small and medium-sized farms, farmers or large, medium and small feed processing plants.

Note:
1. Before using the machine, it is necessary to adjust the screw of the pressure roller to the appropriate position. The pressure roller and the pressure plate should be closely combined, and the three adjusting screws should be on the same horizontal plane.
2. Please fill the oil tank before using the machine. Do not idle the machine for more than 2 minutes.
3. Double-check the belt and the screws before operation.
4. Clean up the rest after use to prevent damage to the machine.
5. If the pressure roller cannot rotate normally, please tighten the screws that control the pressure roller first, and then try to power it on. If it still does not work, you can appropriately loosen the screws next to the pressure roller and then tighten them slightly again (without special tightening)

Precautions:
1. When using, it should be noted that there should be no foreign matter such as stones and ironblocks in the raw materials. After the pellet machine has been working continuously for morethan ten shifts, the pressure roller oil hole, the universal joint oil hole, and the linkage shaft oilhole need to be filled with high-temperature lubricating grease to make the pressure roller Goodworking performance and extended bearing life.
2. During granulation, it is strictly forbidden for the pressure roller to contact with the templateto run idly, and the continuous feeding can not be interrupted. At the same time, the pressureroller shaft nut is locked to avoid loosening and damaging the spindle keyway.
3. When granulating, there is no granulation, no discharge, the template should be removed, andafter opening one by one, some fiber feed can be added appropriately to restart the granulation.
4. Always check the tightness of the screws in each part of the machine. If there is oil leakage inthe gearbox, replace the oil seals in time, and check whether the bearings in the machine headare short of oil.
5. When the pellet machine is working, do not reach into the feeding port with your hands. Ifnecessary, use wooden sticks to help feed the pellets.
6. Before turning on the machine, it is necessary to add less material before turning on the machine. When shutting down, leave a small amount of feed in the machine to prevent the pressroller of the machine from contacting the template from idling.
7. If the machine is stuck in operation, stop it immediately, press the pressure roller until thebolt is flat, and then restart the machine.
8. Each time the work is completed, the adjusting pressure roller bolts must be loosened.
9. Iron or stones cannot be put into the griller.
10. Check the elasticity of the belt, and the bearing frequently. Add oil in time when it needs to.

Noteice:
1. We suggest that high-power machines should be directly connected to the main power supply, as the voltage reaching the machine is stable. If the voltage is unstable and the current exceeds the rated current of the motor, it is easy to burn out the starting capacitor.
2. It is recommended to directly connect to the power supply as much as possible. If the machine is not connected to the power supply, different situations may occur, and the wires are not durable. The wires will gradually burn out over time.

Item Included: 239227
Chicken Feed Grinder Pellet Mill Machine Farm Animal Food Granulator 10mm Holes Plate 3 Head Rollers 200KG/H