Introduction:
The mold is 85mm, if you want to seal other size of cans, please contact us before place an order.
The machine is suitable for all kinds of circular iron, plastic cans, paper cans and other round containers (the material of the can body is relatively soft and cannot be sealed). It is reliable in quality, easy to operate and lighter in weight. It is an ideal for the food and beverage industry equipment.
Parameters:
Productivity: 10-20/min
Range: φ45-100mm（1.75"-3.94"）
（Our standard machine is 85MM, and we can also customize molds in the range of 45-100MM. If you need it, you can contact us for customization.）
Height: 45-200mm(1.75"-7.8")(others need customized)
Power: 370w
Dimension: 41×30×68cm（Desk Type）
Operations:
(1)Adjusting:
1)Top mould, lower mould and tools should be prepared.
2)Loosen the nut between the top pressure head and base plate.
3)Replacing the top mould and lower mould respectively.
(1)Adjusting height of the can, turn off the on-off of top mould and lift, lift the lower mould by inching to the position that hob touch the top mould. Loosen the nut on adjusting screw rod and adjust the height according to the can, put a can with cover to adjust the top mould touch it just then rotate the screw rod to lift the can 2-3mm to let cover keep sealing and rotating then lock the nut.
(2)Adjusting hobs, don't make the hobs touch the top mould when adjusting or damage them. From left to right, rotate the can shaft by inching to make the highest point of left can toward the bearing of hob. Then adjust the distance between left hob and top mould about 2mm and ensure the distance between the upper edge of hob and top mould about 0.5-0.8mm that vary based on the thickness of the plastic can. After that, lock the nuts on base plate. The left hob effect the roll rim and the right hob effect shaper. The method of right hob adjusting is the same as left hob, only the distance between the upper edge of hob and top mould about 1.0-1.5mm.
Item Included(020154):
Techtongda 110V Auto Can Sealer
