Phyun 12V Single Car Led Light Bar Wiring Loom Harness High Beam Quickly Turn 9005/H4 High Beam Driving Light

DESCRIPTION:

Plug and play wiring harness for quick installation of driving lights. The included 9005 (HB3) and H4 adapters can trigger the driving lights of the high beam without the need to cut or solder any wiring. Simply unplug the HB3 or H4 connector on the back of the headlight and plug in our adapter to complete! The drive light will only trigger from the high beam, and the switch can only act as an isolator.

It can be used directly without any modification.

Contains everything needed to connect the lights: ON / OFF switch, 40A relay, 30A fuse, PVC pipe cable protector, heat shrink wrap relay. Total length 8.8 meters of wiring (full extension) 2 meters wiring from relay to adapter 2.9 meters wiring from driving light connector to relay, from H4 or HB3 adapter to relay total cable length 2.2m 12vDC 30A rated fuse kit 12vDC 40A switch relay button ON / OFF switch UV rated insulation 1x DT connector for 1 light bar Each DT connector is rated for 15A

HB3 and H4 are the most common wiring connections among most popular brands and models. If your car does not use H4 or HB3, this harness can still be used to connect the high beam.

The switch has an indicator light that will illuminate when the light is turned on. The switch is connected to the household self-locking terminal of the control line, and the terminal is provided with a sheath to prevent short circuit. At the same time, the terminal can be pulled out and directly inserted into the control position of the original lamp, so that the newly installed lamp can be controlled by the switch provided by the car. As for why the lamp is not directly connected, it is because the lamp power of the car is relatively small, and the original line can only withstand less power. If it is forcibly connected, it will cause the circuit to burn or the line to accelerate aging, which is extremely safe. Hidden dangers.
Package include:
as shown