The PL6800 is designed to provide stable power, on demand up to 100 amps, to a vehicle electrical system to support module reprogramming. It is also designed specifically for fleet service battery charging with a maximum charge rate of 100 amps, to quickly and effectively bring 4- and 8-battery Group 31 packs back to full charge.
Features - 100A Flashing Power Supply & Fleet Battery Charger
- 0-100A (on demand) power supply mode to maintain system voltage
- Power supply mode provides optimal support for vehicle reprogramming and ADAS recalibration
- Power supply mode has minimal voltage ripple (<100mV)
- Power supply mode features Rapid Load Response (RLR) technology
- 100/40/10A charging modes allow quick, efficient charging of all battery sizes
- Properly charges Flooded, AGM, Spiral Wound, Deep Cycle and Marine Batteries
- Forced start mode allows charging of totally dead batteries
- Battery repair mode overcomes battery sulfation to restore reserve capacity
- Reverse polarity protection and battery fault detection
- Extra-long 13' cable reach
- PowerJaw clamps provide improved access to hard-to-reach batteries
- PowerJaw clamps allow the hood to be closed (most vehicles) during ADAS calibration
Specifications - Voltage: 12V
- Operating Voltage: 12V
- Operational Mode: Automatic
- Charging Rates: 100/40/10A
- Charging Phases: 7
- Reverse Polarity Protection: Yes
- Battery Fault Detection: Yes
- Temperature Compensation: Yes
- SKU: ZX9MDCO153124
WARNING: 