1.INSTALL THE BRIDGE/ADJUST THE STRINGS
If the strings are loose when you received, you need to adjust it. Please loosen the strings slightly , and slide the bridge to the below of the strings .( Don't make it too tight, since the strings are easy to break).
2.ADJUST THE BOW ROD
The correct tightening principle is the spacing between the bow hair and the bottom of the bow rod is just the thickness of pencil.
Note: inorder to reduce the effects of sweat, the neck is without paint.
Specifications:
1. Violin Color: Natural Color
2. Weight: 48.18oz / 1366g
3. Size: 4/4
4. Rosin Dimensions: (1.89 x 1.22 x 0.63)"" / (4.8 x 3.1 x 1.6)cm (L x W x H)
5. Panel Dimensions: (14.02 x 8.27 x 2.76)"" / (35.6 x 21 x 7)cm (L x W x H)
6. Bow Length: 29.13"" / 74cm
7. Violin Dimensions: (23.43 x 8.27 x 2.76)"" / (59.5 x 21 x 7)cm (L x W x H)
8. Case Dimensions: (31.30 x 10.04 x 4.72)"" / (79.5 x 25.5 x 12)cm (L x W x H)
9. Back Material: Basswood
10. Side Material: Basswood
11. Face Material: Basswood
12. Tailpiece Material: Aluminium Alloy
13. Top Material: Maple
14. Chin Rest Material: Blacked Wood
15. Tuning Peg Material: Blacked Wood
16. End Pin Material: Blacked Wood
17. Violin Bow Material: Arbor
18. Viola Bridge Material: Maple
19. Arm Length: Above 60cm
20. Age: Above 11 Years Old
21. Violin Length: 59cm
Note:
1. When you receive the violin, please notice that the bridge is wrapped in paper and stowed underneath the tailpiece. Don't discard it. It should be installed in the middle of the two F Holes.
2. When you receive the bow and the hairs are loose, don't worry. Use the screw to tighten the frog so that the hair has tautness.
3. When you find that part of the bow hair is broken, it is normal, please cut off the broken part and the bow can be used normally.
4. Be careful to not over tighten your bow. The hair should have a slight bounce to it without touching the stick after placing it on the strings. Usually about 1/4 of an inch distance from the low point of the curve to the hair is ideal.
5. Hold the rosin with your index finger and thumb, and thus tighten up the bow, evenly smear the rosin on the bowstring up and down. Suggested use: before smearing, rip a trace on rosin to make it powdery for quick and even smearing. Try to keep your hands away from rosin or pad with a tissue while smearing; otherwise it will become too sticky to clean.
6. If the string falls out, don't worry, it can be reinstalled, please consult customer service.
