ROKOO K300 UV Glue for Crystal Glass Bonding, Clear, 50 ml

Feature:
Type: UV Glue
Capacity: 50ml
Appearance: Colorless or light yellow transparent liquid
Viscosity cps: <110 (Brookfield DV-II viscometer,25 degC, SC 4-15 rotor 150rpm)
Hardness(Shore D): 75 (GB/T 531-1999 curing test )

Use these steps:
Depending on the material surface treatment, surface dry and clean, no weak boundary layer.
Interface adhesive bonding material on the need for continuous coating, be careful not to disperse.
Light positioning the glue into the short ultraviolet curing lamp radiation, until the hand nudging fixed.
To remove the excess glue with a cutter to scrape the glue overflow, or a soft cloth, paper towel and gently
erase the excess glue can also be dipped in acetone, alcohol wipe ;
Full cure time high radiation, until fully cured, note the temperature is not too high;
Dipped in acetone, alcohol, cleaning materials with a soft cloth or paper towel and gently wipe the bonding good material.

Instructions for use:
The adhesive surface clean, dry and free of grease, you can wipe with acetone, hair dryer .
The UV lamp positioned curing, the curing rate is dependent on the glue to absorb light energy from the
light source associated with, the light transmittance material and other factors .
The operation should not squeeze too hard to be sticky, and shall not be repeatedly moved apart adherend.
Using the rest of the glue not fall back to the original packaging to avoid contamination.
K-300 is a modified UV or visible light curing acrylic adhesive, low odor, high transparency, high bonding strength,low viscosity, easy deaeration, typically used in large- area glass crystal bonding, such as: glass mosaic,glass crafts, crystal crafts.
Storage: This product is sensitive to light and heat, you need storage in a cool, dry place, away from light below 28 degC, valid for one year .