SOVOL 3D SV07 Plus 3D Printer with Klipper Firmware, 500mm/s Speed

【Max Print Speed 500mm/s】Klipper firmware allows SV07 Plus to speed up to 500mm/s at Maximum. SV07 Plus is equipped with 480x800 high resolution 5 inch touch screen which brings you totally different experience from knob screen and normal 4.3inch touch screen in the market. Klipper also offers a range of function options, including the height map and input shaper, while you could DIY based on your specific needs. 【High Flow Hotend Achieves 300℃ Printing】All-metal hotend comes with a larger melt zone, which offers high flow up to 20-30mm³/s that greatly reduces the possibility of clogging. An extra large fan at the rear of the extruder offers triple airflows to quickly cool prints and ensures good layering for better results. It makes the high speed and high temperature possible at the same time. No more PTFE replacements or firmware flashes needed to print with different materials easily, like ABS, Nylon 【Larger Print Volume & Heating Faster】Equipped with 600W Meanwell Power supply, SV07 Plus brings super excellent and stable heating performance. Upgraded 420W heated bed can be heated to 60℃ in 90 seconds, which is 30 seconds faster at least than most printers in the market ( All sizes ). If you own a SV07 Plus, not only you own a 300x300x350mm larger print volume printer, but also you get super faster heating speed and printing speed. 【Planetary Dual Gear Direct Drive Extruder】 With Sovol's self-developed Direct Drive Extruder that comes with planetary dual gear set, SV07 Plus offers a higher drive ratio and lighter motor for precise extrusion. We also have added a large external knob to make feeding easier, so you can focus on your printing project with minimal interruptions. 【25-point Bed Leveling】SV07 Plus features 25-point auto leveling with an inductive sensor to detect and compensate for unevenness in the heated bed. This precise and smart technology makes it possible to get a fantastic first layer. Note: Set initial layer height to 0.3mm when slicing will help you get optimal results. If you have any adhension issue we recommend you to wipe the PEI surface with alcohol before the next printing.