24in chainsaw gas Specification
Material: Manganese Steel, Rubber
Power Type: Gasoline
Color: Orange
Process: Quenching
Assembly Required: Yes
Power Source: Gas Powered
Ignition System: Hand Pull Start
Engine Type: Single Cylinder, Air-cooled, 2-Stroke
Oil Mixture: 25:1(Gasoline: Oil)
Chain Length: 60.96cm/24inch
Displacement: 65cc/72cc
Tank Capacity: 0.77l/26oz
Speed: 2700rpm
Chain Fuel Tank Capacity: 0.42l/14oz
Power: 3.4kw/3.9kw
Maximum Cutting Diameter: 58cm/28.33in
Product Size: 104*27*33cm/40.94*10.62*12.99in
65cc/72cc Gas Chainsaw 24" Bar Gasoline Powered Chain Saw 2-cycle Wood Cutting--Using Traditional Axes to Cut Wood Is Inefficient and Very Tiring. and Our 2-Stroke Gasoline-powered Chainsaw with 3.4kw/3.9kw Strong Power and 65cc/72cc Displacement Is an Ideal Choice for You to Cut Wood with less Effort, and It Is Easy to Assemble&Operate.having It Makes Your Work Easier and Simpler.
Package Included
1x chainsaw gas powered
1 Pair X Goggles
1 Pair X Gloves
1x Funnel
1x Guide bar
1x Guide bar Cover
1x Chain
1x Mixing Pot
1x English Manual
All Accessories for Assembly
Application
our chain saw gas power Is Suitable for Forest Harvesting, Cutting Wood, Pruning Branches, Gardening, Home Woodworking, Bamboo Sawing, Logging, Light Felling, Diy Crafts, Ranches, Farms, and so on to Meet Different Needs
Starting Method:
1. Fill Fuel and Chain Oil Tanks Respectively,and Tighten the Caps Securely.
2. Put the Switch to "I" Position
3. While Holding the Throttle Lever Together with the Throttle Interlock, Push in the Side Throttle Lock Button and Release the Throttle Lever to Hold It at the Starting Position.
4. Pull out the Choke Knob to the Closed Position.
5. While Holding the Saw Unit Securely on the Ground,Pull the Starter Rope Vigorously.
6. When Engine Has Ignited First ,Push in the Choke Knob and Pull the Starter Again to Start the Engine
7. Allow the Engine to Warm up with the Throttle Lever Pulled Slightly.
How to Assemble the Chainsaw:
Pull the Guard Towards the Front Handle to Check That the Chain Brake Is Not on.
Loosen the Nuts and Remove the Chain Cover.
Install the Attached Spike to the Power Unit.
Gear the Chain to the Sprocket and, While Fitting the Saw Chain Around the Guide bar, Mount the Guide bar to the Power Unit. Adjust the Position of Chain Tensioner Nut on the Chain Cover to the Lower Hole of Guide bar.
Notes:
Please Mix Gasoline with Oil at the Ratio of 25:1. the Oil Mixing Ratio Should Not Be Incorrect or Biased. the Chain Oil Tank Must Not Be Short of Oil. Do Not Use Inferior Engine Oil As a Matching Oil or Chain Lubricant.
Please Perform Necessary Maintenance, Dust Cleaning, Oil Injection, Etc. After Each Work.
Before Using the Chain Saw, Apply Engine Oil to the Air Filter to Ensure the Normal Use of the Machine.
Please Read the English Manual Completely Before Installing. and Pay Particular Attention to the Safety Instructions Included.
Please Allow the Slight Color Difference Caused by the Shooting Light and 1-3cm Error Due to Manual Measurement and Make Sure You Do Not Mind Before Ordering.
