Brushless upgrade for nCPx

If you are looking for some more power... plus easy plug and play for your Nano CP, then look no further. Takes about 10 minutes to install and it is ready to go. I put a dab of silicone sealant on the bottom of the frame just where the motor seats, just to make sure it does not move with use. Also, put a dab of silicone on the signal connector plug. I used the same flight settings that were used on my stock motor set up.The picture instructions do not give you any assembly tips, but if you have been flying micros for awhile then these things should be automatic. I flew for about 3 minutes flight time with a stock battery doing full 3D moves. I noticed some reduction in my total flight time ( 45 seconds). The tail holds just fine and really no bad tendency's. If you really are picky then, some tweaking of your radio settings are needed to get the full performance from the new motor. If you do not fly 3D then the normal settings should be more than good. I am still looking for some good 200 mah 45*C batteries that will fit in the stock frame. I heard that HH has some but I am unable to find them on their website. Happy flights with your Nano CP BL Rich