40pcs Stainless Steel Molds Ice Lolly Ice Cream Stick Holder Commercial

Commercial Ice Cream Stick Mold Stainless Steel 40 Pcs Spiral Popsicle Mold
 

 
Item Specifics:
 
Material: 304 Stainless Steel
Capacity: 40pcs / 82ml
Color: Stainless steel
Quality level: Qualified
Size: 365*240*290 MM
Each Mold Size: 32*29*125 MM

This is an ice cream mold, using the old method to make ice cream.
 
Handmade popsicles are made of milk, milk powder, sugar, fruit, red beans, mung beans, glutinous rice and fruit juice.
 
Material: SUS304 food grade stainless steel material production, manipulator welding.
 
 

usage method
 
1. Clean the ice cream mould before use.
 
2. Put the ice cream stick into the cover plate.
 
3. Pour in the ingredients you have prepared.
 
4. Cover the cover plate and put it into the refrigerator or special machine for freezing.
 
5. Refrigerator freezing more than 6 hours, according to their own equipment to control the freezing time.
 
6. After all the ice cream is frozen, take out the whole mold and put it into 40 ℃ warm water. Swing left and right for 10 seconds, quickly pull up the mold cover to open the mold completely.
 
7. Take the special container, pull the loose mold rod, quickly remove the cover, and then put the special container into the freezer.
 
8. After using, the ice cream mould should be cleaned, dried and stored.
 
Note: the temperature of the refrigerator for family use is relatively low, so the ice cream will be hard to make. DIY ice cream is full of happiness, and the taste must be good. When the ice cream is just condensed, it is very soft and smooth, and the refrigeration time should not be too long.
 

 
Package included:
 
1 X Stainless Steel Popsicle Mold
 

 
Note:
 
1.Please allow 1-3cm error due to manual measurement. Please make sure you do not mind before you bid.
2.The colors may have different as the difference display, please understand.