Add wireless Z-Wave controls to a single electric device with the Qubino Flush 1D Relay. This universal relay module turns virtually any device or appliance with a large power supply (110-240 VAC/24 VDC) into a smart Z-Wave device to add into your Z-Wave network. This module is perfect for adding remote control to electric gate or door openers, heaters, water suppliers, or any other device that use a dry contact (110-240 VAC or 24 VDC). The Qubino Flush 1D Relay fits in behind a wall switch, between your selected device and switch, and requires a neutral wire for setup. If your selected device uses 24VDC power supply, it must be installed in a location between the power supply, the selected device, and a connected wall switch. Connecting a digital temperature or door sensor (sold separately) allows you to create automation scenes. Command fans or heaters to turn On/Off when a set temperature point is reached, or control garage doors or gates to Open/Close. The Qubino Flush 1D Relay also acts as a Z-Wave repeater to improve the range and stability of your Z-Wave network. Contents: Flush 1D Relay Module, Instruction Manual. NOTE: Remote commands using Z-Wave requires a Z-Wave network controller (sold separately). Manufacturer Part #: ZMNHND3. Warranty: 2 years.
WARNING: 