For Toyota Camry 2007- 2014 LED Headlight High/Low Beam+ Fog Light Bulbs Kit A++

LED Quantity(each bulb): 2pcs* Bridgelux COB chips

Operating Voltage: DC 9-32V(fit 12V,24V vehicles)

Color Temperature: Pure White 6000K

IP68 rated water and dust seal, over 50000hrs lifetime

Beam Angle: 360 degree

Material: Aviation 6063 aluminum profile

Operating Temperature: -40-80 degree Celsius

Usage: headlight,fog light

Advantage:

*Latest Bridgelux COB chip(USA) light source, 3 luminous faces no blind zone

*Engineering beam pattern design throw more light on road evenly at appropriate angle without foggy light

*Xenon white light reflect road paint/signs better to show clearer road situation during night driving

*270 degree low beam angle with cut-off line, will not dazzle oncoming traffic

*All-in-one heat conduction system keep the light bulb in appropriate working temperature

*Built-in constant current CPU, instant full brightness without start-up relay

LED headlight advantages:

****LED lamps are more energy and power than conventional halogen lamps.

****The brightness is close to the xenon lamp, but the LED lights are illuminated without delay to enhance road safety.

****Instantly start without strong current impact, improve battery life by more than 30%.

****Fast cooling , using the most advanced, heat-dissipating structural design.

****The power driver adopts a wide voltage constant current mode which has a simple structure, so that the automobile can flexibly cope with various voltage unstable conditions, and has achieved the purpose of less component damage. Compared to HID ballast maintenance, The repair probability is very low which is less than 80%.

****Low heating temperature, The working temperature of helium can reach 800°-1000°

****LED headlight has a simple structure, and the parts are less than the xenon lamp, which is lower than the xenon lamp failure rate!

****Car LED headlight color temperature are balancing. Xenon bulbs are clear in the same color, about 6000K.

Install Caution

1. As a safety precaution, make sure that the car has had time to cool down properly before starting the installation process.

2. Put the vehicle into park or make sure it is securely in gear.

3. Be sure to turn off the ignition and remove the key.

4. Be careful to avoid burns, especially when turning on or off the vehicles lighting.

5. Be careful to avoid crushing or cutting the bulbs. Also make sure to not touch the bulbs with your fingers, as this will cause blotting.

6. Fully examine the connection of the contact points, ports and the wires as faulty connections can cause lighting problems.

7. Make certain that the end of the bulb does not come in contact with the interior light shield of the headlight when adjusting the bulb.

Package Included:

4Pcs LED Headlight Bulbs

2Pcs LED Foglight Bulbs