Essmo™ Holographic Bubble Black Heat Transfer Vinyl HTV T-Shirt 20" Iron Press SP05 20"x60"

Material Specification:

• PET Composition
• Thickness:145 Microns / 5.7 Mils (Please make sure plotter is capable of cutting such thickness)
• Heat pressure sensitive backing
• Special Design Finish

Application Instruction (Home Iron)

• Set iron dial between Cotton and Linen
• Cover design with Kraft paper or non-stick cover sheet
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds
• let it cool for about 30-45 seconds;and then gently peel back the clear plastic until it is completely removed.

Application Instructions (Heat Press)

• Cut in reverse
• Weed excess material
• Preheat all fabric prior to pressing for best results
• Apply design at 305;F/150;C;for 10-15 seconds
• let it cool for about 30-45 seconds;and then gently peel back the clear plastic until it is completely removed.

Applies to:

• 100% Cotton
• Poly / Cotton Blends
• 100% Polyester
• Leather

Laundering:

• Wait 24 hours before 1st wash
• Machine wash warm or cold / mild detergent
• Dry on normal dryer setting
• Do not bleach or dry clean

Note: Material will be rolled for shipment. Due to the nature of the material, wrinkles might appear after unroll. In this case, peel off the transfer tape (clear film) and re-apply transfer tape onto the film with heavy flat item on top such as yellow page for 15 minutes, the film will be back to the flat shape.