DIGITEN Water Flow Control Meter LCD Display Controller+G1/2" Water Hall Sensor Flow Meter Flowmeter Counter 1-30L/min+G1/2" Solenoid Valve Normally Closed N/C+DC 12V Power Adapter

TECHNICAL SPECIFICATIONS For DFC15 Controller: Controller Power Requirement: 12VDC Power Adapter: Input: 100-240VAC; Output: 12VDC, max 2A Adapter lead length: 1m Measuring Accuracy: ±1% Output for Solenoid valve: 12VDC, max 5A Temperature Sensor: 0-125°C/32-257°F, NTC3950, Accuracy: ±1°C/±1°F thread: M8 Max Total Volume: 999999 G/L Quantitative Range: 0-9999.99 G/L Flow Rate Range: 0-9999.99/LPM(GPM) Cable Length: 1m Dimensions: 88mmx126mmx30mm Weight: 200g Operation Environment: Temperature: 0-50°C/32-122°F; Relative Humidity: <85% For G1/2" Flow Sensor: Flow range:1-30L/min Allow compression:Water pressure 1.75 Mpa below Sensor:Hall effect Cable length:15cm. Error: ± 2% For G1/2" Solenoid Valve: Working pressure:0.02-0.8Mpa Operation mode:N/C,normally closed. How to work: 1. Set K value, quantitative value, max alarm value, properly install the flow sensor and solenoid valve. 2. Press the RUN/STOP button, the controller works, total will continuously display the current flow volume, and current flow rate, and the faucet will start animated display. 3. When the flow reaches the quantitative setting value, the controller turn off the solenoid valve automatically, and the total value stop, faucet animation will be stopped dropping, flow rate back to zero. 4. Pressthe RUN/STOP buton again and the controller will repeat the same job. Note: 1, This controller work with the solenoid valve up to 5A, but this kit come with 2A power adapter. If drive a large solenoid valve, please use suitable power adapter. 2, Ensure the solenoid valve and flow sensor direction is the same with water flow. 3, Avoid the water into the controller. Package includes: 1 x DFC15 controller 1 x G1/2" flow sensor 1 x G1/2" solenoid valve 1 x Power adapter 1 x Temperature sensor 1 x Manual