Ekena Millwork 25 3/8"OD x 3 3/8"ID x 1 3/8"P Cole Ceiling Medallion (Fits Canopies up to 9 1/8")

Although medallion had minor "casting marks" on edge, once slightly sanded and painted, looks fine on ceiling. Also painted very easily with two coats of Benjamin Moore latex paint. I glued to ceiling and used around 12 small brads to attach. Only slight minor issue was that the ceiling bezel on my chandelier had just slightly different diameter of cut-out hole in medallion, just a bit tricky to line up - especially that only support lip for medallion is near outside edge, nothing close to hole - so don't tighten too much. Think design works well on normal 7' ceiling in a 12' x 20' dining room - not too much, but enough to notice on the ceiling

Had a few defects around the ceiling light fixture that weren't covered by the standard escutcheon plate. This did the job and added some depth and visual interest to the ceiling. Use a good quality latex adhesive to attach it and if possible brace or tape it in place until the adhesive sets. The medallion comes primed. I painted mine before installing with the same ceiling paint I was going to use on the ceiling and got a perfect match. Included are two photos of the finished medallion with the chandelier lit and unlit.