BRIDJIT Curb Ramps for 12ft Driveways, 3 Piece

BRIDJIT Curb Ramps for 12ft Driveways, 3 Piece

• Will BRIDJIT Fit My Curb: 1. Measure 20” out from top edge of curb out into the street. 2. Measure from the lowest point of the gutter, perpendicular to the first measurement. This distance should be between: 1.75” TO 3”.
• These curb ramps are not bolted down to the storm gutter, just bolted together, forming a 150lb. to 200lb mass, (depending on the number of sections used).
• Bridjit Curb Ramps are designed to reduce the impact of a rolled curb entry by as much as 80% and can be used for protect the undercarriage of all types of vehicles, such as cars, trucks, golf carts, motorcycles, boat trailers and can be used to facilitate the movement of wheeled carts and hand trucks.
• Easily installed with only a hammer and screwdriver; Bolt together with pre-inserted galvanized bolts to connect the sections, not to the ground.
• Neighborhood friendly, Bridjit has a built-in full length waterway allowing normal drainage. The angled ends guide excessive water flows out and around the ramp, assisting in the elimination of debris.
• Galvanized bolts measure 1/2 x 7-1/2-inch and are pre-inserted into the center sections. Each section weighs 50 pounds and measures 2-1/2 x 48 x 16 inches (H x W x D). The 2-1/2"" height at the center tapers to 3/4-inch at the top and bottom of the ramp.
• Bridjit Curb Ramp is Eco friendly. The average American contributes 4 tires every year to our landfills. Each BRIDJIT rubber curb ramp set uses 12 passenger tires, thus helping to reduce the number of scrap tires in landfills, making it the Green solution to your jarring curb problem.
• 100% made in the USA. A2Z Sell is an Authorized Dealer of Bridjit Curb Ramps. Bridjit, low profile car ramps, Corvette ramps, car ramp extenders for low profile cars, low profile car ramps for corvette, bridjit curb ramp, curb ramp for driveway.