Natural Chemistry 07395 Extra Strength Stain Free, 1-3/4-Pound

STAINfree Extra Strength is an all natural stain remover that contains industrial strength ascorbic acid. It quickly removes metal staining without adding phosphates to your water. It is ideal for treating staining on all pool surfaces. Use with Natural Chemistry's METALfree and you have the ultimate 1 2 combination for stain fighting!Note: Operating the pool for a couple of days without chlorine can create an algae concern. Follow your pool dealer’s recommendations on steps you can take to protect your pool from algae during this metal stain removal process.Balance pool water chemistry before using STAINfree Extra Strength: pH:7.2 7.6, Alkalinity: 80 120ppm, Calcium Hardness: 200 400ppm, Phosphates: below 100ppb Note: Stain removal products work best when the pH is on the lower side of acceptable range (7.2)Important: Before starting the metal stain removal or water discoloration process (step 4), a pulp based filter aid must be added to cartridge and sand filters. DE filters must be properly charged.Lower chlorine level to 1ppm or less (A high chlorine level or adding oxidizing agents during the process will prevent STAINfree Extra Strength from working as designed.)Surface Staining: If the surface is stained, add 1lb of STAINfree Extra Strength per 10,000 gallons as close to the stained area(s) as possible with the pump off. Keep the pump off overnight.Water Discoloration: If the entire body of water is discolored, put the pool on recirculate, add 1lb per 10,000 gallons of STAINfree Extra Strength around the perimeter of the pool and let the circulation run for one hour. After one hour, shut the pump off and let sit overnight.Before turning the pump back on, brush the pool walls and floor thoroughly.Turn the pump back on and add METALfree around the perimeter of the pool at a rate of 33.9oz per 20,000 gallons.With the pump still on, vacuum the pool surfaces very thoroughly.After vacuuming, clean filters: Sand filter backwash for at least 3 minutes and then rinse for 2 minutes Cartridge filter clean filter and filter tank thoroughly DE filter backwash and recharge with DETest and rebalance water. DO NOT SHOCK THE POOL FOR AT LEAST 1 WEEK.Note: If chlorine level is low, add small amounts of chlorine. Do not exceed 2ppm. For salt generator pools, a granular shock is recommended instead of turning the generator to its boost (superchlorinate) function after the recommended 1 week.Use METALfree as a weekly maintenance to prevent future metal staining. Apply 4oz per 10,000 gallons once a week.Do not swim until stain procedure is complete and normal chlorine residual is established.