6V 12V 10A 3-Stage Solar Panel Charge Controller Regulator PWM Battery Charger

Specification:

material: plastic

System voltage: 6V, 12V

Output current: 10A, 3A

Power range: ≤60W(6V), ≤120W(12V)

Overload and short circuit protection: yes

No-load loss: ≤5mA

Voltage drop of charging circuit: ≤ 0.2V

Discharge circuit voltage drop: ≤0.1V

Protection class: IP30

Working temperature: -40°~55°

Installation and usage:

First determine the output mode of the controller, the factory default setting of the device is normally open mode. If you need to set it to pure light control mode or light control plus timing mode, you need to open the shell by setting the DIP switch to change the discharge mode

When the button "on" is 1, the button "off" is 0, normally open, pure light control

Connect the battery first. If the connection is correct, the battery light will be on

Connect the wires to the solar panel. If connected correctly, the Charge light will turn on or flash 10 seconds after being outdoors in the sun. Otherwise, check the connection

Make sure the solar panels are placed outside in sunlight

Connect the load. If reversed, the LED light may be damaged

Please pay attention to the anode and cathode to avoid reverse connection

The package contains:

1* Automatic solar charge controller