Grundfos Ups 40-160 F Cast Iron Recirculation Pump

Grundfos Cast Iron Recirculation Pump with Relay 890 W Maximum Power Output Oval Valve Connection and a Corrosion-Resistant Impeller

The pump is of the canned rotor type, i.e. pump and motor form an integral unit without shaft seal and with only two gaskets for sealing. The bearings are lubricated by the pumped liquid.

In order to avoid problems in connection with disposal, great importance has been attached to using as few different materials as possible.

The pump is characterized by:

• 3-speed motor.
• Ceramic radial bearings.
• Carbon axial bearing.
• Stainless steel rotor can, bearing plate and rotor cladding.
• Aluminum alloy stator housing.
• Cast Iron Pump Housing.
• Stator with Built-In Thermal Switch
• The motor is a 1-phase motor.
• The pump is supplied with a standard module in the terminal box
• The standard module is to be connected to the mains supply via external contactor.

Controls:

• Relay: With Relay

Liquid:

• Liquid temperature range: 14 to 248 Degrees F

Technical:

• Approvals on nameplate: CUL

Materials:

• Pump housing: Cast Iron
• EN-JL 1040
• ASTM 35 B - 40 B
• Impeller: Stainless Steel
• DIN W.-Nr. 1.4301
• AISI 304

Installation:

• Range of ambient temperature: 32 ... 104 Degrees F
• Maximum operating pressure: 145 PSI
• Flange standard: USA Oval
• Type of connection: F
• Pipe connection: 32
• Pressure stage: 145 PSI
• Port-to-port length: .4528 in

Electrical data:

• Power input in speed 1: 690 W
• Power input in speed 2: 760 W
• Maximum Power Input: 890 W
• Main frequency: 60 Hz
• Rated voltage: 1 x 115 V
• Current in speed 1: 6.95 A
• Current in speed 2: 7.45 A
• Current in speed Three: 8.4 A
• Cos phi in speed 1: 0,86
• Cos phi in speed 2: 0,89
• Cos phi: 0,92
• Capacitor size - run: 80 ?F/250 V
• Enclosure class (IEC 34-5): 44
• Insulation class (IEC 85): H