KEY CUT BY CODE SERVICE:
Please send me a message with the key code after purchasing.
You can get the code from the dealer with proof of ownership OR from the driver-side door lock.
Same-day service and shipping
Toyota Toy44D Transponder Key
Chip: 4D67 (Master)
Cross Reference: TOY44D-PT, 5910834, 89785-08020, 89785-60160
FCC ID: GQ43VT20T IC: 1470A-1T
Frequency: 315 MHz
Compatible with the following:
2004-2010 Toyota Sienna
2008-2010 Toyota Sequoia
2008-2010 Toyota Highlander
2005-2010 Toyota Tacoma
2007-2010 Toyota Tundra
Toyota / Lexus Smart Keymaker OBD Programmer
Smart and efficient. Program a transponder key in about 20 seconds! No 30-minute wait, and no pin
codes. Just connect to the OBDII port and go. Simply the fastest way to program TOY44D or
proximity keys.
To program keys when all keys have been lost:
1. Using the transponder master key, switch the ignition to the “ON” position
2. Insert the tool into the OBDII port. You will hear one beep. After about 3 seconds, the tool
will beep 3 more times indicating that the vehicle has been placed into programming
mode.
3. Remove the tool and the key.
4. Perform the following steps to program the keys:
a. Close all doors
b. Insert the first master key for 5 seconds (do not turn)
c. Insert the second key for 5 seconds (do not turn)
d. Insert the valet key for 5 seconds (do not turn)
e. The programming mode should automatically end. If, for some reason, you need to
end programming mode manually, simply insert and remove the first master
key 5 times (do not turn).
To program additional keys when you have one working master key:
1. Using the working master key, switch the ignition to the “ON” position
2. Insert the tool into the OBDII port. You will hear one beep. After about 3 seconds, the tool
will beep 3 more times indicating that the vehicle has been placed into programming
mode.
3. Remove the tool and the key.
4. Perform the following steps to program the keys:
a. Close all doors
b. Insert the first master key needing programming for 5 seconds (do not turn)
c. Repeat step B for each key needing programming
d. Insert and remove the original master key 5 times (do not turn) to end
programming
