Tile Cutter - Tile Cutter Hand Tool Manual Tile Cutter For Ceramic Tile Subway Tile Glass Tile Backsplash Even Cut Curves In Tile And Glass Tile Without A Wetsaw No Water No Mess Watch The Videos

Tile Cutter – Not just any Tile Cutter This is The Amazing Tile And Glass Cutter made in UK a manual Tile Cutter that lets you cut straight, radius and wavy lines in ceramic tile and glass tile, mirrors, stained glass and floor tiles. Despite what you may think the cutting wheel is not sharp, in fact it is probably the dullest tool you will own, just the hardest, the hardness of the cutter blade along with the special angle ground into the scoring wheel allows The Amazing Tile And Glass Cutter to cut thick and thin materials like wall tiles, Subway Tile, Floor Tile, Glass Tile, Most Porcelain Tiles, Mosaic Tile and even Quarry Tile pavers Up To 3/4" Thick. The Secret to using The Amazing Tile And Glass Cutter is to follow the instructions carefully. Practice on a spare tile to work out the correct pressure, usually not enough pressure is applied to start but it can cut better with less pressure sometimes especially on glass. Cutting on the floor instead of on a board at waist height will stop even pressure being applied along the score. Not oiling the cutting wheel and checking it is turning freely first will cause the wheel to bind, drag and even lock up and just scratch instead of evenly scoring the surface and will prevent the tile cutter from working correctly. Holding the Cutter by the plastic grips when scoring with your strongest hand means that you are only applying minimal pressure if any on the cutting wheel at the point where the scoring is happening. When Cutting Stained Glass, Plate Glass, Picture Framing Glass or Fused Glass the cutting wheel should be oiled every single score, oil will run down onto the glass and will not only cool down the glass and give a cleaner cut it will also extend the life of the cutting wheel. If you can wipe the oil off the surface and there is no score line visible – you need to increase the pressure – make sure you are holding close to the wheel and use the 2 handed method if needed especially if you do not have a lot of strength in your hands or are cutting a very hard material.