Sanmadrola 17.7''x158'' Frosted Window Film Non-Adhesive, Frosting Privacy Film for Glass Windows, Self Static-Cling Decorative Window Cling for Home Office UV Protection Cross Pattern

Sanmadrola Window Privacy Film, Frosted Removable Glass Covering for Bathroom, Opaque Static Cling Heat Control Door Sticker for Home Office Living Room Bath Room Non-Adhesive Flower Privacy Film for Window

Installation Type:Peel and Stick

Ultraviolet Light Protection:Keep 96% UV out

Static and self-adhesive, not need glue to paste. Tear off easily and not leave any trace.

For air-conditions and heaters can block out 45-85% sunlight heat in summer. The window film also can Reduce at least 30% warmness lost in winter.

Q&A

Q1:The window film can't adhesive on the window. Could you have some suggestions?

A1:Our window film is a static self-adhesive window film without need glue. Please check the backing film is be torn off. Spray a lot of water both on the window surface and window film back during installation for effective attachment. Finally scrapted all the bubbles and extra water.

Q2:Do you apply the smooth side to the window??

A2:The smooth side on the window for better adhesion.

Q3:Q:The window film's edges can't adhesive on the window. Could you have some suggestions?

A3:A:When it curls at corners or edges, please try to blow the films with a hairdryer or soften it by soaking in warm water. Set a hairdryer to high heat with low speed and run it over the film, holding 1"-2" (2.5-5cm) away from the film surface.

Installation Steps:

Step 1. Keep Window or Glass Clean.

Step 2. Measure the window and determine size.

Step 3. If you need to cut,draw lines the window film with markers. Make sure the edge of the protective film and the glass surface have a 1cm gap.

Step 4. Wet the Window or Glass with water( Soapy water will be the best choice ).

Step 5. Remove the Static Film from backing protect sheet ( Please MAKE SURE you have removed it before you apply the matte window film to glass).

Step 6. Squeegee away air bubbles and redundant water with a scraper or hard card.

Step7.Cut off the extra film edges.

(The window film only paste on flat, clean, and smooth glass surfaces.)