ECCPP AN8 45 degree Swivel Hose End Fitting fit for braided fuel line and stainless steel braided fuel hose Aluminum Alloy black -AN6 -AN8 -AN10 Oil Swivel Hose End Fitting

Product description
Size : AN8 45 degree
Installation
Professional Installer is Highly Recommended !
1.Mark desired length of hose by wrapping it in tape. Using a fine tooth hacksaw or cut off wheel cut through hose at the specified length. Once finished ,remove tape and clean away any debris from inside of hose.
2.Hold or clamp socket in place with soft vise jaws and insert hose by turning hose clockwise. Turn hose clockwise until hose is snug against the back of socket threads.
3.Mark hose with tape or marker at rear of socket .This will later show you if the hose has pushed out of the socket during assembly, and if so ,may leak when used.
4.Liberally apply assembly lube to nipple before placing nipple into soft vise jaws and turning socket onto nipple threads.
5.Start threading socket over the nipple by hand .Continue to tighten by hand as far as possible . Using our adjustable wrench, continue to turning socket onto nipple threads until the base of socket is within.

Installation notice
(1)avoid twisting hose when installing
(2)avoid some slack in assemble for changes in length that occur underpressure
(3)when routing hose line, provide a smooth bend radius.Avoid sharp bends which may cause hose to collapse and restrict flow

The package included
1 piece AN8 45° Swivel Hose End Fitting