Detail:
Powered by DC 9V battery x 1 (included )
Material:Metal + Plastic
Testing Capability: Diamonds, Diamond simulation (e.g. CZ), Metal
Auto Off: N/A
Initial warm-up: ~ 20 sec.
Indicator: LCD display & LED indicator
Type: Diamond Tester
Package included:
1 x Diamond selector tester
1 x Protected leather bag
1 x 9V Battery(s)
How To Use:
1. Open the power, the power indicator light, instrument began preheating, after a few seconds instrument can be used.
2. Take the naked drill to be tested into support tray appropriate sunken hole, and its mesa upwards. Those already inlay need not put tray hole in, you can use hand to hold it.
3. According to the weight of the tested diamonds and measuring the temperature place to move several bright leds.
4. Take down needle sheath, handhold instruments, the right index finger touch the conductive plate on the back cover of instrument. To make the probe vertically and gently contact with mesa of measured diamond.
5. Carefully watching the instrument, if the rest of the emitting diode light reflect yellow, when light place moves to nine diodes with accompany beeping, this explains those tested are for real diamonds. On the contrary, if light place moves to insufficient ninediodes, and without accompany beeping, this explains fake diamond .
Noteļ¼
1. Turn on the power of the tester and heat the probe. It usually takes 20 seconds to touch the hot needle to the surface of the sample.
2. According to the signal sent by the thermal conductivity meter, it can be determined whether the sample is diamond.
Features:
