Kern HO 2K UCI Hardness Maximum Tester for HV 2

UCI Hardness Maximum Tester for HV 2

• The SAUTER HO measures by using a vibrating rod which vibrates at ultrasonic frequency
• This pressed onto the sample at a defined test force
• At the lower end there is a Vickers indenter
• Its resonant frequency increases as soon as an indentation is created
• Through appropriate adjustment of the device, the resulting change in resonant frequency is matched with the corresponding Vickers hardness
• The HO ultrasound hardness testing system is primarily used for measuring small forgings, castings, welding points, punched parts, casting tools
• The flanks of gear wheels as well as for measuring the influence of warmth or heat
• Advantages compared with Rockwell and Brinell: Less test force and therefore only microscopic, small penetrations means that the testing
• Advantages compared with Vickers: Demanding optical measuring is not required
• You can therefore carry out measurements directly on-site, for example, on a permanently installed workpiece
• Advantages compared with Leeb-The high requirements for the weight of the test object are no longer required, in most case
• Standards: The device fulfils these technical standards
• DIN 50159-1-2008: ASTMA1038-2005: JB/T9377-2013
• Measurement data memory saves up to 1000 measurement groups each with 20 individual values
• Mini statistics function: Display of the measuring result, the number of measurements, the maximum
• Minimum value as well as the average value and the standard deviation
• The device can be set to both standard hardness test blocks and also to up to 20 reference calibration values
• When doing this it is possible to measure different materials quickly
• Without having to re-adjust the device to the individual material
• Scope of supplies display unit, UCI sensor unit, transport case, software to transfer the saved data to the PC

• Weight: 12 lbs