Stand Up Weed Puller Tool - 44" Long Handle with 4 Steel Claws, No Bend No Kneel Weeding, Heavy Duty Root Remover for Lawn & Garden, Chemical Free, Easy Storage

I ordered the Fiedyka Stand-Up Weed Puller Tool to remove the numerous different weeds growing in my yard. The only assembly required is to connect the three handle parts by pushing in the spring clips and pushing the parts together. The Weed Puller is built like a tank with solid steel. The Footpad and Claw assembly is held tightly together with one hex-head bolt and nut. The bottom of the handle is held tightly together by two button‑head socket cap screws and nuts. This Weed Puller should last many years because I don't foresee any parts breaking. The Weed Puller is flawless. It's very easy to use and worked on every variety of weed I pulled up. Just place the Weed Puller over the weed, step on the Footpad to push the Weed Puller into the ground, then tilt the Footpad back towards you and remove the Weed Puller from the ground. You then have to remove the weed and dirt from the four Claws. There is nothing difficult in using this Weed Puller. Determining where the center of the weed was located is the biggest challenge to removing the weed. When the weeds were between different grass types, the Weed Puller pulled up the weed, the grass and the dirt. Anything trapped between the Claws gets removed. I also used it to pull up and transplant volunteer marigold plants. The Weed Puller pulls up about 3 inches of dirt and roots each time, which makes the odds of the transplant successfully growing much greater. When done using, most likely there will be dirt on the end of the Weed Puller that needs to be washed off. The end of the Weed Puller can be hung on a nail/hook to dry and store. I highly recommend the Fiedyka Stand-Up Weed Puller Tool if you have weeds to remove or plants to transplant.