Pertronix 91665A Ignitor II Adaptive Dwell Control For Toyota 6 Cyl
Pertronix 91665A Ignitor II Adaptive Dwell Control For Toyota 6 Cyl
Hero image 0 of Pertronix 91665A Ignitor II Adaptive Dwell Control For Toyota 6 Cyl, 0 of 4
PerTronix

Pertronix 91665A Ignitor II Adaptive Dwell Control For Toyota 6 Cyl

|1 rating
Car
Check if this fits your vehicle

Key item features

  • Adaptive dwell maintains peak energy throughout the entire RPM range, reducing misfires while improving engine performance
  • Develops on average 4 times more available energy between 3000 and 5000 RPM, and 2 times more available plug voltage
  • Compensates for inherent electronic delay by adjusting the spark timing throughout the entire RPM range
  • Synchronized peak current and spark timing reduces heat build-up
  • Senses startup and develops more energy for quicker, easier starting
  • Built in reverse polarity and over current protection shuts down the system, preventing component damage
  • Epoxy molding makes our module impervious to dirt, oil, grease and moisture
  • Stable timing ...no need for adjustment
  • Will trigger most CD ignitions
  • Legal in all 50 states and Canada. (C.A.R.B. E.O. #D-57-22)
  • Guaranteed for 30 months
Current price is See price in cart
Price when purchased online
  • Free shipping

How do you want your item?

How do you want your item?
Ships to
Arrives between May 15 - May 18
|
Sold and shipped by PartsHawk
4.183908045977011 stars out of 5, based on 174 seller reviews(4.2)
Report an issue with this seller
Return policy

About this item

Product details

Specifications

Warranty

Customer ratings & reviews

4 out of 5 stars
stars1 rating1 review
How item rating is calculated
  1. 5 stars0% (0)
  2. 4 stars100% (1)
  3. 3 stars0% (0)
  4. 2 stars0% (0)
  5. 1 star0% (0)
Filtered and sorted results would be available on the new 'Customer ratings & reviews' page.
Sort by |

Showing 1-1 of 1 review

Apr 21, 2018
DMader
4 out of 5 stars review

Ok so far

This was pretty easy to install but instructions were poor for this specific model (used on my 74 Landcruiser). Instructions said only one screw would line up & hold down the breaker assembly but 2 lined up so I used 2. Where the wires and grommet exit the ignitor 2 assembly is directly in line with the hole in the distributor so there's not enough room for slack to allow the plate to move/advance. I just tried to route as best I could to make some room for a bit of a loop. I've since seen that in other installations online. The engine started right up after installation and the time just happened to be perfect. Don't know yet how it will perform as it too cold to drive topless yet here in SD

Review from jegs.com
Helpful?4JDTYTC0KNW5192889564