YILIKISS 2 Stroke 4HP Heavy Duty Outboard Motor Boat Engine With Air Cooling System 63cc

Note: We don't have the MSO of the motor. And we can only provide CE certification, there is no other certification can be provided, thanks for your understanding!

Description

The Outboard Motors modle of SPOE2.5 has been designed and is intended for the skippers of small boats (carrying capacity less than 4 people ), powered by outboard motors and operating in near waters.

Starting Procedure:
1. Lower engine to running position and check the following
• Fuel level
• Engine mount secure
• Propeller clear
2. Loosen air-vent screw on fuel tank cap by 2 or 3 turns (if fitted)
3. Firmly connect fuel hose to both fuel tank and engine
4. Squeeze primer bulb until it becomes firm
5. Make sure throttle grip on handle in START position
6. Clip lock plate onto emergency-stop switch and tie lanyard to your wrist
7. Pull out choke if starting cold engine
8. Start motor by pulling starter handle (manual start)
9. Push choke back in
10. Check fuel pump to ensure membrane is not torn out
11. Check carburetor to ensure that draining screw is not opened

Mounting An Outboard Motor:
The method of securing an outboard motor to the vessel.
Use of hand-tightened screw thread clamps. These clamp the transom of the vessel between the engine mounting bracket and the screw thread plates. Their tightness should be checked each time the engine is used. A safety rope or chain should also be used to secure the motor to the vessel and prevent the motor from dropping from the boat if the clamps get loose during vessel operation. On larger outboard motors, the mounting bracket is usually bolted through the transom plate. This is a more secure method, but regular checks must be made for looseness.

Trim Angle:
By changing the outboard motor's drive angle, the vessel's bow can be made to rise or fall. The performance and stability of a vessel depends a great deal on correctly trimming the outboard. The correct trim angle depends on the vessel ' s handling characteristics, the size of the outboard, the sea and loading conditions. Care must therefore be taken to ensure the outboard is trimmed correctly under different sea and loading conditions. On smaller outboards, the trim angle is adjusted manually by moving an adjusting rod to different holes in the mounting bracket. The bigger outboards usually have a Trim Switch fitted on the remote control level.

Technical Data:
Engine type: Single cylinder
Stroke: 2 stroke
Cooling System: air-cooled
Engine model: 1E48F
Displacement: 63cc
Max. Power: 2.3kw/8000rpm
Start system: Recoil start(manual start)
Ignition system: CDI
Mixing ratio(Gasoline:oil) 25:1
Gasoline tank capacity: 1.2L
Idle speed: 3000rpm
Gear ratio: 2.08(27/13)
Propeller diameter: 18cm
Propeller options: 7-1/4*5-A inch
Running speed: 15--18km/h

Instructions On Refueling:
The gasoline is highly flammable and explosive:
1.Don't smoke,when refueling,keep away from fire, flame and ignitions of other sources.
2.Shut off the engine of your outboard engine before refueling.
3.Use unleaded gasoline only. Use 2 stroke engine oil.
4.The mixing ratio of gasoline and oil is 25:1. Mix the gasoline and oil and shake well.
5.Don't spill the gasoline.Use clean cloth wipe off the spilled gasoline.
6.When start the engine, keep at least 3 meters distance from the refueling point.

Package includes
1 x 2-Stroke 4HP Outboard Motor