Featues
1Made of rustproof allcast aluminum
2Can be adjusted between 0 20° which enables the users to achieve trimming quality.
3.Can be used Dry or Wet
A high-power, low-noise plaster dressing machine
Motor Power :550W
Speed :2800 rpm
How it works: water mill
Working Grinding Disc: Quartz Sand Disc/Carborundum Disc
Standard: Emery Sheet
Applicable Grinding Disc Aperture: 25.5/32
Golden light wet dry dual-use gypsum dressing machine:
Manual water supply is achieved by manually turning on and off the faucet, while automatic water supply is achieved by the machine having an electromagnetic valve. Similar to a washing machine, there is no need to turn on and off the faucet. Simply turn on the power and start the machine to allow water to enter
Work grinding disc: quartz sand disc/diamond sand disc, standard configurat: diamond sand disc: suitable for grinding disc aperture: 25.5/32
1. Place the machine flat (with 4 holes on both sides of the base to support customer installat of expans screws), connect the inlet pipe (controlled by the outlet valve of the inlet pipe during operat, synchronized with the motor switch), and pull out the outlet pipe (inlet pipe during operat).
2. Power on, start the motor, and check for any abnormal noise during no-load operat.
3. There are three angles for the work platform, which can be adjusted using the adjustment screw (7).
4. Replace the sand piece. Cut off the power, open the front cover (11), and remove the grinding wheel cover (1) (if inconvenient, you can also remove the grinding wheel cover (1) at the same time (if inconvenient, you can also remove the water spray pipe (13) at the same time to replace the sanding disc).
5. After completing the work, it is necessary to promptly clean up any remaining debris.
neral faults and troubleshooting
1. There is abnormal noise in the work
Reason: Loose shaft sleeve; The flatness of the grinding disc is not good.
Exclus method: The sand piece (16) can be removed, and the two fixing screws on the shaft sleeve (2) can be tightened again with an attached wrench; Replace with new sand pieces.
2. After being powered on, the machine does not work
Reason: Motor fuse; Motor burnt out; The switch is malfuncting.
Exclus method: Replace the fuse, (22) the socket is built-in; Replace the motor; Replace the switch
