10Pcs W5W T10 LED Bulbs 4014 26SMD Car Interior Dome Roof Lamp License Plate Signal Tail Box 12V White Light

1. Completely design and installation, without changing , without damaging the structure of the car's lamp, just plug it in Available
2. Professional design of high-quality and high-strength glass fiber circuit boards, fine silk screen printing, no burrs around;
3. High- large wattage 100% chip resistors provide accurate working current of the lamp group;The LED purity is high, no lampshade is needed to filter light,
4. Dedicated welding process, large solder joints, and excellent heat conduction scheme,LED car lights can make the vehicle control circuit not easy to oxidize.
5. LED has low power consumption. When it reaches the same brightness as traditional bulbs, the power consumption is only 6% of traditional bulbs, and it also saves electricity and ,It has an ultra-.

Product note:No need to modify the circuit, directly replace the traditional glass bulb, pay attention to the high temperature of the bulb to prevent !
When installing, refer to the product dimensions and pay attention to the size of the installation location. carefully and do not squeeze the LED chip to avoid damage. The LED has positive and negative polarity, if it is not bright, turn the direction and reinstall;
Product Name: T10 26SMD Bulbs
LED light source: Highlight 4014 lamp beads
Commodity voltage: 12V
Color temperature: 6000K
Main scope of application: Clearance light, reading light, license plate light, roof light, door light, tail box light, side turn light, small light, etc.
NOTE:
This bulb is Canbus Error Free for 95%+ vechiles system, but the load resistor (decoder) may needed for some of the Europe and American Vechiles, such as for , , , , , -Bens, etc.
Colour:White light
Material:PC board

Package Contents:
10 x Car Led Bulb

Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.