'Cut out around print as close as you can / feel comfortable doing. Use sharp scissors or blade 2) Float on water for 3 to 10 seconds 3) Lightly wet area where decal will be placed so it can slide around easily 4) Transfer decal from blue decal paper onto car with soft brush or finger 5) Position as needed with brush, finger, or very gently with smooth toothpick 6) Absorb excess water with dry brush. Gently push out water from underneath decals. 7) Optional but recommended: Clear coat entire car after adding decals for protection. ---Once decals have been installed, wait at least 4 hours before adding Clear coat over entire car for protection. Avoid handling car or decals with oily fingers as they can cause weird results with clear coat! Pro tip: Use Micro Set and Micro Sol for better results... -apply some Micro Set liquid to area first, then transfer decal (try not to transfer too much water onto car) -Micro set is supposed to help decal stick to surfaces more easily (such as panel lines) -apply micro sol over decal to help it lay flat more easily (especially useful for complex surfaces or wrapping around edges) -be careful as micro sol will make decal more fragile, do not use too much, do not use if not needed -not needed for install but may help youCustom WaterSlide Decal for hot wheels 1/64 a1
