4PCS Golf Cart Seat Cover Red Pleated for EZGO TXT 2014+, Valor, Front Rear Seat

? FOR EZGO Medalist TXT models (1994 to 2013) The serial number and manufacturer's number can be found on a plate located in the glove box on the passenger's side of the vehicle. The serial number is either six or seven numbers and does not indicate the model year. The manufacturer's number does reflect the model year. This series will have one letter and three or four numbers which will include two numbers indicating the last two digits of the year it was manufactured. Newer EZGO carts have the words "TXT", "Freedom TXT","RXV" or "Freedom RXV" listed on the side of the cart, located vertically beneath the armrests. Once you have the serial number, then enter your serial number into the top left search box on the EZGO website to verify the make and model of your cart! 1x Front Lean Back Cover (Will not fit two pieces seat back)1x Front Seat Bottom Cover1x Rear Seat Lean Back Cover (will fit most rear seats in the ) Approx. Seat Back size 35"x12"1x Rear Seat Bottom Cover (will fit most seats in the ) Approx. Seat Bottom Size 37.5"x14" ? Golf cart seat cushions get damaged, as passengers continually get in and out of your golf cart. Cracks and tears may begin to occur with extended use and that is the perfect time to your seat covers. ? STAPLEON SEAT COVER SET Remove the seat from the cart.Remove arms and hinges.Center new seat cover over old, pulling corners evenly.Snug up seat cover and temporarily tack or staple into place.Check for proper fit before proceeding, making adjustments as necessary.Staple permanently. Remove the back if it has one. Center new seat cover over old, pulling corners evenly.With the back cover properly fitted, temporarily staple along the bottom of the backrest.Some models have a dip in the top of the backrest, so you will need to make relief cuts in the fabric. (Be careful not to cut too deep)Pull fabric until it conforms to this dipped area and staple into place. More cuts may be needed. Be careful not to rip the fabric at buts when pulling.Staple permanently. BE SURE TO STAPLE ALL SEAMS BEFORE TRIMMING. DO NOT USE !