RANMEI Cnc Interface Adapter Breakout Board For Mach3 Usb Parallel Port Control

Features:
* Brand new and high quality
* Made of high quality materials, sturdy and
* Fully supports for and other computer software to support parallel port control
* USB power supply and peripheral power supply are separated to protect computer security
* Peripheral wide voltage input, 12-24V, with anti-reverse connection function
* All input signals are isolated and can be connected to tool emer gency stop and limit to protect computer safety
* O ne relay output port to control the spindle switch. Output port P17 port
* O ne channel outputs 0-10V analog voltage through optocoupler isolation, which can be controlled with the corresponding analog interface converter to control the spindle speed. Output port P1 port
* All 17 ports are open, can be connected to optocoupler drive, and can control 5-ax is stepper motors
* P1 is for PWM output, which can control the spindle speed regulator through optocoupler input
* Can be driven by common cathode or common anode input level up to 5V

Specification:
Size: about 90*61*15mm
Cable length: approx. 50 cm

Notice:
The laptop must have its own parallel port, USB to parallel port cannot be used! ! for software supports WIN for XP (recommended!), WIN7 32-bit can barely use it, but WIN7 64-bit does not support it! The USB to parallel port cable cannot be used because the parallel port converted in this way is virtual.

Package Included:
1 x 5-ax is for breakout board
1 x USB cable

Note:
1.The real color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness.
2.Please allow slight manual measurement deviation for the data.