Calibration Solution for Multimeter Users Standard Resistors Offering Consistent Accuracy at an Affordable Price Point

Features:

The standard resistors for multimeters on the market are modified with European standard sockets or thermocouple sockets. They are not tight when into the multimeter, which results in a large error in the resistor. Some sellers also use multimeters that are not very accurate and reliable.

This product uses a 3D printed shell with a beautiful design. It is also tight when into the multimeter. There is no problem of poor contact with the multimeter jack. It has been tested for 6.5-digit multimeters and has good accuracy.

Specifications:

Part name: multimeter standard resistor

Material: abs

Color: as shown

Size Size: As shown in the figure

Pitch: P=19.05mm

Shell material: 3D printed for PLA material

type: 4mm lantern banana head

Applicable objects: handheld and desktop multimeters (less than four and a half digits)

Accuracy and temperature drift: 0.1%25PPM (actual resistance accuracy is above 0.05%)

OR resistor (2-wire short circuit) actual resistance is about 1.4mQ

Model: 100R/1K/10K/100K/1M/10M; 200R/2K/20K/200K/2M/20M

Package content:

1*standard multimeter resistor

Note:

1: Please allow 1-2 cm error due to manual measurement, please make sure you do not mind before ordering.

2: Due to the difference between different monitors, the image may not reflect the actual color of the item