RANMEI For Benbox Grbl Stepper Motor Control Board Driver For Diy Laser Engraver With Power Requirements Above 12V 2A

Features:
* Brand new and high quality
* Made of high quality materials
* Suitable for DIY desktop la ser engraving machine, dispensing machine printer, plotter
* MINI USB interface, 12V power supply, cable included! Send software
* Dual Y-ax is interface, can drive 2A 4-phase 2-wire stepper motor
* Large MOS tube, onboard DC step-down module, for jumper ADJ can manually adjust the la ser voltage to control the la ser power

Specification:
Interface: USB
Size: 97mm*54mm
Power Requirements: Above 12V 2A
Support stepper motor: 2-phase 4-wire motor within 2A
Input voltage: 12V(voltage will affect the la ser effect)
Power interface: DC5.5- 2.1(positive pole on the inside, negative pole on the outside)

illustrate:
This la ser board does not have a voltage stabilizing module
The motor cannot operate higher than 2A. When the motor operates at 1A to 2A for a long time, please pay attention to heat dissipation.

Package Included:
1 x USB 2-axis stepper motor driver board
1 x USB data cable

Note:
1.The real color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness.
2.Please allow slight manual measurement deviation for the data.