Product Description: This product consists of pitch calipers and sensors, which are adsorbed together by magnets on the back of the sensor. After removing the sensor, it can support the main rotor with a maximum of 700 mm stuck, which is convenient for use in 250,380,450,500,600,700,90 oil helicopters and 700 electric helicopters. The maximum measurable degree of positive and negative inductors is 90 degrees and the resolution is 0.1 degrees.
Product Specification Characteristics: Built-in digital gyroscope to detect rotor angle. Backlight LCD is used. Possessing angle zero and locking function. Detectable angle range (+90 degrees). Have the function of automatic screen inversion. Applicable to 250-700 mm main rotor. Built-in power saving function turn off power automatically after 3 minutes standby. Body size: 108x53.7x16mm
Applicable blade width: 20mm~75mm. Angle measurement range: +90 degrees. Measurement resolution: 0.1 degree. Working voltage: 3.0V/DC. Current consumption: 3mA. Working temperature: 0-40 ℃. Resolution: 0.1 °
Explain
1. 0N/0F - On/Off. 2. HOLD key - angle lock. 3. ZERO key - reset to zero. 4. Place the instrument on a horizontal table, the ZERO button, and the LCD display show 0.0 ° when the value returns to zero. At this point, the measured angle value is the relative horizontal angle value
The following is the usage method (for reference)
1. Regardless of whether the horizontal plane on which the helicopter is placed is absolutely level, it is necessary to find a relatively horizontal plane on the helicopter, such as the motor and tailpipe. The helicopter should be in a stationary state for the second time
2. After finding the relative horizontal plane, ZER0 to reset to zero
3. Measure the angle of the propeller with a pitch ruler, including positive and negative angles, accurate to 0.1 °, and support reverse rotation
4. If it is the same helicopter, when measuring on different tabletops or on the front and side of the helicopter, it is necessary to the ZER0 key to zero before measuring to prevent the tabletop from tilting forward, backward, left, and right
usage method:
1. Use a screwdriver to the back cover of the pitch gauge and open the battery compartment
2. Place the "+" side of the battery facing upwards into the battery slot
3. Cover the back cover and tighten the screws
4. Finally, attach the pitch caliper and sensor magnet together, and they can be used
Color: Black
Material: plastic
Without 2 x CR2032 batteries
Package Contents:
1 x Digital Pitch Gauge
Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
