RuiJiao Multi-Purpose Metal Adhesive Glue - Iron Sealant for Leak Repair, Waterproof, Ideal for Casting Workers and DIY Repairs, Strong Bonding Agent

RuiJiao Multi-Purpose Metal Adhesive Glue - Iron Sealant for Leak Repair, Waterproof, Ideal for Casting Workers and DIY Repairs, Strong Bonding Agent
Features:
Casting compound has good heat resistance, and excellent shrinkage. It is often used for sand holes, pores and pits in metals such as iron, steel making, and aluminum making. It also includes defects found during fine processing. It is used as a general structural adhesive.
It can be welded with glue, with glue, and bolts with glue. It has the characteristics of oil resistance, water resistance, wear resistance, , resistance, strong adhesion and high hardness.
It is used to repair the defects of steel, iron, aluminum and other castings, as well as the defects found during finishing, and can also be used as a general adhesive.
Two-component room temperature curing adhesive, which is packaged with metal hoses. It is formulated with epoxy resin, curing agent, toughening agent, reactive diluent and various fillers. It has good heat resistance, and less shrinkage.
The repaired and cured caster glue layer is often tested at a temperature of 25, its hardness is about HB80, and it has strong wear resistance, which can fully meet the requirements of use.
Product Description:
Instructions：
1.Clean the.Before using the casting glue, be sure to clean the parts of the casting that need to be glued with sandpaper.
2.Make glue. Take out the glues of groups A and B according to a certain proportion, then them a clean glass or paper, mix thoroughly with a small stick, and stir for some, the more uniform the glue, the better. If the stirring glue is uneven, it will affect the adhesion of the glue, and the cured glue will become soft or the glue layer will not be cured.
3.Apply glue. When applying glue, attention to filling shrinkage holes and pores to gaps in the pores, which will shrink curing and affect the bonding effect. Generally, the adhesive layer should be 1-2mm higher than the of the adherend. In addition, the adhesive layer should not be too thick or too thin. Second floor. The bonding workpiece must be positioned to the dislocation of the bonding or the overflow of the adhesive layer. For repairing copper and aluminum castings, if you are worried about the color difference between the glued glue and the, you can infiltrate a little copper powder or aluminum powder the of the glue gluing, so that the glue can cover up its color curing.
The package includes:1x Casting Glue A, 1x Casting Glue B, 1x Water Container