Feature:
*9-tube 500W 5530 M5 kit
*5530 three-mode sine wave 24-60V 28A output
*support most 500W ebike electric bike ,scooter
* LCD instrument: including function, total mileage, single mileage, lamp indication.
Speed measurement mode: 1 motor Hall 2 controller analog Hall signal,3 speed sensor signal, instrument control vehicle switch, car light......
* light power interface: Connect the lamp switch, lamp and to provide power consistent with the battery, such as 24V/36V/48V
Specification:
*Material:metal
*Color: silver (As Pictures Show)
*product name：ebike controller kit 500W
*size : approx 110x55x30MM
9-tube lithium-ion three-mode sine wave Rated voltage range: 24V/36V/48V/60V Rated power range: 500W~800W Maximum current range: 18A~30A line battery undervoltage protection point:
19V/30V/41V/52V(if necessary, the battery undervoltage protection point can be adjusted to the required value through the instrument) Suitable for the motor phase Angle: 60°/120° (automatic recognition and adaptation)
Dimensions: 94*70*57 mm,
Hall linear EABS brake adopts finger-dial control electronic brake, and the electric brake changes from weak to strong with the deepening of the finger-dial Angle, and finally holds the motor.
Instruments control 6km/h boost and real-time cruise, or set 6 seconds to automatically enter the cruise state
P01 Set backlight brightness 1 to 31 Darkest 3 Brightest, the current setting is 2, and the brightness is medium
Parameter Setting page P02 Set kilometer/mile 0 to kilometer and 1 to mile. The current value is 0 to km
P03 Set the battery voltage type to 24/36/48/60V. If the current value is 48, the battery parameter is automatically changed to 48V lithium battery
Parameter Setting page P04: Set the automatic sleep time. If the value is set to 0, the sleep is not entered. If the value is 1-60, the sleep is entered without any action within the corresponding value
Parameter Setting interface P05 Sets the number of gears. If it is set to 0, it ranges from 0 to 3.
If set to 1, 0~5 files;
2 is 0~9; 3 is 0~4;
If it is set to 4, it is 0 to 6
Parameter Setting page P06 Set wheel diameter Unit inch for Precision 0.1 inch. The value ranges from 5 to 50. The current value is 20.0 inches
Parameter setting interface P07 Set the magnetic pole ratio of the motor according to the number of magnetic steel and deceleration ratio, the larger the value, the slower the speed
LCD screen size 48*77 (mm)
Package content:
1xdisplay
1x controller
Note:
1. The real color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness.
2. Please allow slight manual measurement deviation for the data.
