1406 Carburetor Replacement for Performer Series 600 CFM 4 Barrel Square Bore with Electric Choke Compatible with Chevy Corvette Silverado Ford Mercury Mustang Bronco GMC Pickup Truck

Carburetor for Edelbrock 1406 Performer 600 CFM Square Bore 4-Barrel Electric Choke

■The carburetor is suitable for 5.0L 305 Cu, 5.2L 318 Cu, 5.7L 350 Cu, 5.8L 351 Cu and 5.9L 360 Cu V8 engines

■Chevy: Chevelle 350, Cheyenne Pickup, Corvette, Silverado, Camaro

■Ford: Mercury Cougar 289 4V, Mustang GT 289, Mach One 351 Windsor, Bronco 531 m

■GM: GMC Pickup / Truck, Pontiac LeMans T37

■Other Models: Grand Wagoneer, CJ5, J20, Delta 88, Plymouth, GTO, Cadillac Deville

⚠️PLEASE NOTE⚠️:

⚠️■Walmart's Garage Auto Parts Fitment may not be 100% accurate.

⚠️■Please check your owner's manual or the original Factory OE, if you don't sure whether the item fit your vehicle or not.

➤Compatibility: Matching with various intake manifolds, include Performer EPS, Performer RPM, RPM Air Gap, Torker Ⅱ and other similar designs.

➤Design: This carburetor adopts two-piece all aluminum structure, with lower working temperature and less warpage. Can works with manual or electric choke carb.

➤Function: For small and some large engines to get good street performance and fuel economy. It is not affected by engine flashback that means there is no power valve to blow out, and the rod can be replaced in a few seconds without removing the carburetor.

➤Package Included:

1 X 1406 Performer Carburetor

1 X Square-bore Base Gasket

1 X Horn Gasket

1 X Air Cleaner Stud

1 X Clean Tool

4 X Clamps

➤CARBURETOR ASSEMBLY:

■1. Assemble the upper body and lower body of the carburetor.

Care should be taken to install the gasket when operating.

■2. Install the idle speed fluctuation compensator.

Care should be taken to install the gasket and.

Shaped ring to prevent air leakage and loss of compensation.

■3. Install the idle speed shut-off valve.

★First, put the needle valve and spring into the carburetor upper body hole, and set a good seal on the idle speed shut-off valve.

★Then install it to the carburetor and tighten it.

■4. Install the carburetor small throat and each quantity hole.

■5. Install the float and adjust the oil level of the float chamber.

■6. Connect the upper and lower body of the carburetor, install the damper puller and vacuum hose, connect the fast idle speed puller and accelerator pump piston, etc.

■7. Adjust the throttle opening, fast idle mechanism and engine idle speed.

■8. Adjustment of the operating mechanism, throttle manipulation mechanism, so that the throttle lever reaches the fully open throttle position.

⚠️⚠️⚠️➤Notice:

■1. Impurity in fuel may cause clogging in the carburetor, please use the clean fuel to ensure the carb work normally, please clean the automobile oil circuit and air filter before you install the carburetor

Please compare carefully the pictures provided to your part before buying.

■2. Please confirm your old part number matches up with one of the part numbers above

■3. Professional installation is highly recommended (No Instruction Included)