Illume 30.25 in. x 78 in. Wall Hinged Glass Shower Enclosure

[This review was collected as part of a promotion.] These shower doors are a great addition to any bathroom> They are very sleek. The doors are true to size and fit my standard bathroom shower wall frame. Make sure you measure twice before deciding on the size. The hinges are very sturdy and easy to install using just a few tools. You might want some help holding the doors while you measure for the hinges. The doors swing out and I like that because they dont get caught on anything. The glass is really thick and after having on for a few weeks I have noticed that glass treated with Enduroshield that helps reduce water spotting and soap scum accumulation. The glass is 78" tall which is considerably higher than most doors and gives it a much more trendy look. You should expect 4 boxes to make sure that you have all the pieces and parts. Open each up and read instructions and gather all your tools before you start. I know these new doors make our bathroom look so beautiful and hope that they last for years to come.

[This review was collected as part of a promotion.] I'm very impressed with this shower door. The glass is pretty thick at 3/8”, and you can tell it's got resistant coating because after a few weeks of use, there's no visible spotting. We do use a squeegee after use, most of time. The hardware is extremely heavy, you can really notice the heft of the hinges and handle before you install them, and the chrome plating looks flawless. My only gripe, and it's a minor one, is that the hard rubber blocks supplied with it were very hard but not quite hard enough. They are used to set on the floor under the door, and the instructions state that they will set the door to the proper height while marking the holes on the wall, for the hinges. My experience was that the blocks squished slightly, so the door was actually set slightly lower than it should have been, because when I installed the door sweep on the bottom (last step after hanging the door), the sweep is a little tight against the floor. This can be avoided by drilling the holes in the tile about 1/16-1/8” higher than the holes you marked. But this installation gripe aside, I'm very happy with the build quality.