DENEST 12V Electric Transfer Pump 5L DC Transfer Pump, 60W Oil Extractor Pump for Car Marine Boat Scavenge Exchange Transfer Pump Engine Oil Extractor

Description

Car Boat DC 12V Oil Extractor Scavenge Suction Vacuum Transfer Change Pump 5L CA

Specification:
* 100% brand new and high quality
* Material: Metal + Plastic
* Color: Black
* Rated Voltage: DC 12V
* Rated Power: 60W
* Maximum Flow: 5L/min
* Maximum Pressure: 0.8MPA
* Pump Diameter: Approx. 5 cm / 1.97"
* Length: Approx. 16cm / 6.3"
* Cable Length: Approx. 60cm / 23.62
* Clips Length: Approx. 8cm / 3.15"
* Outlet PVC pipe Length:150cm
* Nylon pipe Length:100cm
* Quantity: 1 pc

Features:
* How to use: Start to run the car engine for a while, when oil temperature turns to be about 50 degrees, start pumping oil
* Connect the pump to the power, run it for a while, and observe whether the inlet and outlet is normal
* Open the filler cap,get dipstick out, force the tube into the bottom of the joint, until the tube does not move
* Then put the inlet pipe from the oil dipstick into in end (the tube into the bottom of the tank, the bottom concave place, in order to pump the oil completely)
* As no oil or pumping up very slowly or intermittently, it is generally caused by loose pipes and fittings. You have to install the pipes and fittings again.)
* After oil pumping, remove the tube, and then run the pump for a while, pump the remaining oil inside the pumping clean, or pump water for a while until the pump head gets clean
* If you have not used it for a long time, it may have no suction, then just pour the water in the pump, and run the pump for a few minutes until the air is all out

Note:
This pump cannot pump corrosive liquids such as gasoline and diesel, but can only pump non-corrosive liquids such as engine oil, water, lubricating oil, etc.

What is included:
1x Oil Pump
1x 11mm Outlet PVC pipe
1x 6mm Nylon pipe