Quick Intake Adapter, Automotive Smoke Machine Bladder, Block Tester, Inflatable Leak Plug, Smoke Machine Leak Tester for Vehicle

If the bladder/rubber of your intake adapter is broken or splits, you can buy the spare rubber as a replacement. Diameter: about 37.5mm/1.48in Length: about 113mm/4.45in Please check the vedio, it will teach you how to replace the bladder/rubber.

Attention:

1. Please allow 1cm error due to manual measurement. pls make sure you do not mind before you bid. 2. Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you! 3. Please Clean the inner wall of the intake opening while the Air Filter, and the Throttle connections are removed,so as not to scratch the adapter. 4. This bladder is suitable for the universal intake adapter only !!!

Universal inatake Adapter:

●Universal intake adaptor is an inflatable block off bladder with a pressurized vapor pass-through that allows technicians to test an entire intake or exhaust systems quickly and easily. ●Universal intake adaptor can be used with any brand of smoke machine or diagnostic leak detector to reduce workload on a leak check. ●Block off bladder conforms to any shape of intake / exhaust: Round, oval, square, rectangular and even severely angled and hard to reach intake / exhaust systems, while allowing vapor to pass through for fast diagnostics. ●Compatible with any smoke machine, It fits 100% of automobiles, from passenger car to heavy-duty trucks, to quickly leak test the integrity of the entire induction system with one simple procedure.

Advantages:

●Fit most cars and light trucks ●Quick seal intake/exhaust easily ●Reduce workload in a leak check ●Fits any shape of intake/exhaust (diamter greater than 2") :round,oval,square,rectangular and even severelly angled and hard to reach intake/exhaust systems ●Work with any brand of smoke machine or diagnostic leak detectors

Quick Start Instruction:

1 Clean the inner wall of the intake opening while the Air Filter, and the Throttle connections are removed,so as not to scratch the adapter. 2 Close the Pressure Relief Valve(A) next to the Hand Pump(B). 3 Put the Rubber Component(C) into the intake opening. 4 Inflate the Rubeber Component(C) by pressing the Hand Punm(B) till the intake opening is tightli sealed. 5 Now the system is ready to test,introduce air/smoke into the system by plug the smoke nozzle into the Tube Opening(D). 6 After test,pull off the smoke nozzle,release the inflated air by open the Pressure Relief Valve(A) next to the Hand Pump(B). 7 Clean the adapter for storage,avoid contact with corrosive liquids.

Packing List:

1pc x Intake Bladder or 2pcs * Spare Rubber

Attention Please:

1. Inflating is to seal the air inlet, it still can work as normal even if the inflated airbag is not a perfectly round. 2. Please make sure the diameter of intake/exhaust is greater than 2"