Alpine SWR-8D4 8" 350W RMS Subwoofer+Slim Box+Rockford Mono Amplifier+Amp Kit

Package Includes:

(1) Alpine 8" Car Subwoofer
(1) Rockville 8" Sealed Shallow Mount Car Sub Enclosure
(1) Rockford Fosgate Punch P300X1 300w RMS Mono Car Audio Amplifier
(1) Rockville RWK81 8 Gauge Complete Amp Wire Kit with RCA Cable
10 Drywall Wood Screws (Wood screws are the type of screws; the screws are actually made of metal)
12 Feet of 14 AWG Blue Speaker Wire
2 Spade Terminals

Features of Alpine Sub SWR-8D4:

Alpine SWR-8D4 Type-R 1000 Watt 8" Car Subwoofer with dual 4-ohm voice coils
1000 Watts Peak Power / 350 Watts RMS
4-Layer DVC Winding on Spiral Cut
Reinforced Parabolic Cone Structure with Poly-Mica Dust Cap & Pulp-Kevlar Cone Body
High Altitude Multi Roll Santoprene rubber surround
Progressive Conex® Spider with Reinforced Layer Tinsel Leads
38mm High Temperature Voice Coil
Cast Aluminum Frame With Perimeter Vented Heat Transfer
Heavy Duty 8 gauge Spring Post Terminals For Pin connection or Single Banana Plugs

Features of P300X1:

Brand New Rockford Fosgate Punch Series P300X1 300 Watt Monoblock Amplifier
Number of Channels: 1
Rated Power: (RMS Continuous Power): 200 Watts x 1 @ 4-Ohm
300 Watts x 1 @ 2-Ohm
Total Power (Sum of Rated Power): 300 Watts RMS
Efficiency (average): TBA% @ 4-Ohm / TBA% @ 2-Ohm
Crossover Controls: Front High-Pass/Low-Pass (HP/LP): 50Hz-250Hz 12dB/octave Butterworth
Rear High-Pass/Low-Pass (HP/LP): 50Hz-250Hz 12dB/octave Butterworth
Tone Controls: Front Punch EQ2 Bass: 0dB to +18dB @ 45Hz and/or
Front Punch EQ2 Treble: 0dB to +12dB @ 12.5kHz
Rear Punch EQ2 Bass: 0dB to +18dB @ 45Hz and/or
Rear Punch EQ2 Treble: 0dB to +12dB @ 12.5kHz
Function depends upon LP/AP/HP switch position
Signal Input: Hi/Low level: 2 RCA pair
Power Input Connector: Captive C-Clamp
Power Wire Gauge: 4 AWG
Speaker Output Connector: Captive C-Clamp
Speaker Wire Gauge: 8 AWG to 18 AWG
High level input capable with Auto Turn-On circuit
Features C.L.E.A.N. Set-up
Dimensions (HxWxL): 2.38 x 7.76 x 11.03 (in)

Features of Rockville Enclosure RSST8:

Rockville RSST8 Single 8" .44 cu. ft. 3/4" MDF Sealed Shallow/Truck Subwoofer Enclosure Box
Proudly Made In The USA, Using Only The Finest Quality Materials - For The Best Level of Performance From Your Subs!
Designed For 8" Shallow Mount Subwoofers

Complete Single Subwoofer Enclosure Installation Kit!

This accessory package includes everything you need to install one subwoofer into an enclosure, and wire to connect the enclosure to your amplifier. This package is a top of the line accessory package which we put together and tested.

The drywall wood screws were hand selected by our installation experts because they drill into the enclosure very cleanly, without chipping the enclosure. The speaker wire is 14 gauge. This is way better than using 16 gauge. You can be 100 % sure that your enclosure will have a clean signal to the amplifier with this top of the line speaker wire. These spade terminals have also been hand selected by our installation experts to make the internal wiring simple, secure, and to run the audio signal cleanly.

Video of RWK81: