INTSUPERMAI Electric Copper Rebar Bending Machine Bender Steel Bars18-22mm Hand-Held 220V

Specifications
1. Voltage；220V
2. Power：1100W
3. Bending time:2-2.5s
4. Minimum rebar size (bent to 90°):18MM
5. Maximum rebar size:22MM
6. Net weight:16kg

Warning:
1. Do not bend steel bars in rain, damp places, places with water, or places where water or oil is likely to enter the bending machine. Moisture will reduce the insulation of the motor, resulting in an electric shock accident.
2 In order to prevent an electric shock accident, please use the power supply through the leakage circuit breaker. In addition, in addition to double insulation, be sure to install a correct ground 'ground'.
3. When using it in the outer frame of pipes, heating appliances, microwave ovens, water tanks, etc., do not let your body touch the grounding 'ground wire'.
4. Please fully keep the workbench and workplace bright, and always pay attention to cleaning and rectification. Scattered places will become the fuse that causes accidents.
5. The bending machine may have rectification sparks during use, and sparks will also occur when the switch is opened and closed. Because it is dangerous to work in places where there are paints, coatings, volatile oils, gasoline, gas, adhesives, etc. that may cause flammable and explosive substances, please never use it. At the same time, be sure to stop using it in closed rooms, tunnels and other places without ventilation.
6. For safety, please wear a helmet and safety shoes with rubber soles.
7. Please use protective goggles to protect your eyes during operation. In addition, in dusty occasions, please use a dust mask and a dust collector at the same time.
8. For the installation of the bending push block and accessories, please use the method of stop gauge at the regular position and use the specified tool to correctly carry out. At the same time, the installed cover and bolts have their own important functions, please do not remove them.
9. Before inserting the plug into the power supply, please confirm whether the switch is disconnected to prevent the bending machine from starting suddenly.
10. Do not transport the bending machine when the plug is connected to the power supply. Do not hang clothes on the switch, it is easy to close the switch by mistake, which will cause an accident.
11. Please always pay attention to the soles of your feet and work in a stable posture. Working in an inappropriate state will bring danger.
12. When the bending machine is found to be in bad condition or abnormal during use, please stop the operation immediately and carry out maintenance.
13. Do not use the bending machine and its accessories beyond the scope of its use, and do not perform excessive operations. Improper operation will not only cause damage to the bending machine, but also be dangerous, please avoid it.
14. When the bending machine is running, please never touch the bending push block and the rotating part, and keep your hands and face away.
15. In order to use it safely and efficiently, please conduct regular inspections. If you need to repair, please do not hand the bending machine to someone who does not have repair knowledge and skills, so please go to the store where you purchased it for inspection and repair. Also, be sure to use the specified parts when replacing parts.

Note: Do not use the machine to bend rebars that exceed the maximum bending size, after bending dozens of bars, please cool down before use!

Item Included: 190252
INTSUPERMAI Electric Copper Rebar Bending Machine Bender Steel Bars18-22mm Hand-Held 220V