fankhu 2-4S Brushed ESC Speed Controller for 1/8 1/10 RC Off-Road Monster Truck

320A 2-4S LiPo Brushed ESC Electric Speed Controller with 5.6V 2A BEC for 1/8 1/10 RC Off-Road Monster Truck

Feature:

This device is intended for use with electric model cars and is configured for range selection based on the following information.

Equipped with forward and reverse functions, automatically find the center.

High frequency drive system.

Low resistance field effect inner tube is used.

It has forward and backward functions for cars and boats.

Mechanical budget speed control upgrades.

Compatible with 6-12s NiMH/NiCd or 2-4s Lipo batteries (7.2V-16V)

Fits 1/8 1/10 off-road monster trucks.

Specification:

Operating System: Forward and Reverse

Power supply range: 7.2V-16V

Input voltage: 6-12s NiMH/NiCd or 2-4s LiPo battery

Output current: Forward 320A

BEC: 5.6V/2A

Heat sink: Yes

Cooling fan: Yes

Interference: Yes

Tip:

1. The battery must be connected correctly. At both ends of the terminal board, the red wire is the positive and the black wire is the negative. (Or connect to a standard DC battery plug.)

2. Turn on the power switch, if there is no signal input, the motor will emit a "beep-beep-beep" alarm sound. When there is a signal, the alarm sound stops.

3. Turn on the remote control and adjust the trimmer to the middle (red/green lights are off). Push the accelerator forward, the remote control car moves forward, and the green light is on. Then pull the throttle back to braking. The more the brake is pulled back, the tighter it will be. Put the accelerator to the middle, pull it again, the red light is on, and the remote control car goes back.

Note:

This product cannot be used in humid environments.

Make sure the power supply is negative and not reversed.

For brushed ESCs of 320A and below, the plug-in current is always 1A.

Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!

Please allow 1-2mm measuring deviation due to manual measurement.

Included:

1 X 320A Brushed ESC