Quick-Snap Buried Sprinkler Kit

A gear-driven rotating sprinkler just like the contractors install. Only you don’t have to trench the lawn or pay for buried plumbing. It stays safely buried in place until needed. You can mow right over it. Just snap your hose on to the swiveling quick-connect and water pressure pushes the riser up 5 inches above the ground. A powerful stream throws water 17 to 37 feet at 2.5 gallons per minute and 30psi. You set the rotation from 40-360 degrees. Both settings are right on top and easy to make while the unit is on or off. Most front lawns can be completely watered with just two, each in an opposite corner. When you turn off the water, the riser drops back below ground where it stays ready till next time. You can use a garden trowel to dig a 4 inch hole, 9 inches deep. That’s it: plant it, point it, set it, forget it. No assembly required. Just pull it out of the box and stick it in the hole. Plant them right next to drives or sidewalks, in flower beds—anywhere, really. Corners are good spots. The swiveling hose connect makes it easy to snap on the hose from any direction. Instructions are included and they are very simple. Installation videos are online. This is an industrial strength sprinkler that will give years of faithful service. Depending on your water pressure, you can string two or more Quick-Snaps off the same hose line; you can add a timer at the faucet. These units can be removed and taken with you to the new house when you move or reset when landscaping matures. Without the hassle of buried pipes you can even tilt them in the ground to get just the spray angle you want. Worried about winter freeze damage in your area? You may want to order a Quick-Snap Air Purge. It blows out the water with an ordinary bicycle pump. Each sprinkler comes with its own hose quick-connect and a bright orange cap to help find the unit when the grass grows long, lush and green. Lawns don’t move. Why keep moving sprinklers around? Bury them, instead.